Pencil lead graphite has a very high component of clay in it, so it wouldn't be suitable for dry lubrication purposes. The gun shops sell a dry graphite lubricant, so maybe try that. I have never tied it but if it works for guns, it should work for reels. You can also buy "reel lube" from the fly shops, which is great, and I don't think it needs to be anything more than that.
Originally Posted by
Kevin James
I'm pretty sure the pencil lead would be/do the same.
The graphite powder I'm referring to specifically is an extra fine lubrication graphite.
It's designed as a lubricant to lock cylinders - you know when the keys are tight and the locks don't want to turn/open.
I was put onto the stuff years ago for drag washers.
You are dead right though about the mess and stains it makes. You just have to be careful and remember that a lot is not needed.
With regards to cork maintenance, you only need to do this after extended outings or if you feel sticky drags.
The most important thing is to remove all the old, dried crappy grease that is on the cork - clean it thoroughly!
I generally use alcohol swabs or meths to get the dirt and grease off the cork.
There is a type of grease I use called marine grease that is the best out there.
You need the tiniest bit to wipe on the cork again to re-coat.
Crank drag down and test it - the cork should heat up and swell and you'll soon figure out if it's smooth or still slightly sticky.
Just add a bit more lube if it is and go from there.
Remember - you don't have to drown the reel in grease and oil for it to work properly.
Hope this helps mate.
Last edited by Andre; 22-02-16 at 10:13 AM.
Disclaimer.... none of my posts are intended to be "expert advice"..just opinions from someone who is willing to help where he can.
Bookmarks