There is just something special about damsel flies, they are pretty, slender and graceful. Compared to dragon flies with a stealth bomber appearance, damsels are more lady-like. I’ve been experimenting with all kinds of damsel imitations, with the emphasis on movement. Damsels swim with a side-to-side movement similar to midge pupa and mosquito larva. With this in mind detached body imitations and wiggle damsel imitations have been developed and tied. I’ve never been satisfied with the end result and effort that went into tying these imitations and was convinced there must be an easier way, without compromising on movement.
The inherent movement of marabou feathers and rabbit fur is renowned in fly tying circles. The only drawback with marabou is the fact that the material is not as durable, it had to be rabbit. The next challenge was to create a slender abdomen; commercial zonker strips (rabbit) are too wide. With all this in mind the deadly damsel nymph was born, it is easy to tie and require just a few materials. Fish the fly with a slow hand twist/twitch retrieve with the occasional pause, in the vicinity of weed beds. The fish hit the fly with gusto, ensure there is a slight angle between the rod tip and line to absorb smash takes.
Recipe
Hook: Short shank hook #10 - #14
Thread: 8/0 olive
Tail: Zonker strip
Abdomen: Rabbit dubbing cut from the zonker strip
Legs: Partidge or grizzly marabou
Step 1
Burn the monofilament with a lighter. The space between the eyes should be narrow, grip a 3cm. piece of monofilament with the tip of your scissors and burn the monofilament starting with the one end. Keep the monofilament horizontal and blow out the flame as soon as the flame almost touches the scissors. Let the melted monofilament hang straight down to create an even eye at the end of the stalk, otherwise the eyes will be rather droopy.
Step 2
Use a Minora blade/craft knife to carefully half a length of zonker strip from the skin side.
Step 3
Tie in the eyes with figure of 8 wraps and apply head cement over the wraps.
Step 4
Measure and cut a length of zonker strip, approximately twice the hook shank length.
Step 5
Part the fibers at the tie in point above the hook barb. By moistening the fibers this can easily be achieved.
Step 6
Tie in the zonker strip above the hook barb and half hitch, apply head cement to the thread before you half hitch. Trim the fibers on the length of zonker strip extending forwards. Use these fibers to dub the abdomen and head.
Step 7
Dub the abdomen up to a point just behind the eyes.
Step 8
Prepare a partridge feather. Tie the tip of the feather in slightly behind the eyes, keep the legs sparse, one to two turns of the feather will suffice. Wrap the feather and tie it off.
I find I have a lot of tail hits when I fish flies like this, zonkers included. Sometimes, if you don't strike the fly away, they return for a second hit, but I still miss a pile of fish.
The BFG presented the same problem for me, so I deployed a tandem hook in the tail. problem solved
You are a perishable item. Live accordingly.
niiiice!! me likes!! looks alot like the fly that won the damsel fly swap last year? that been ur inspiration?
that is a nice damsel.
Thank you for the tip on the eyes. Mine always comes out skew (babalas)
"Sometimes one pays most for the things one gets for nothing" - Einstein
Very nice Fish!
Bookmarks