Step 7
Wrap the rubber forward untill u reach the bead.Tighten the rubber as hard and tight as possible.Then move your thread back over the rubber band till u reach the end of the lead wire.(Remember u have a gap here,end the thread on top of the wire.Now u should pull like a madman to secure that rubber.
Step 8
Use a sharp blade and cut the rubber that is directly on top and around that gap I was talking about earlier.Remember to leave a little bit of rubber,don't cut it to short.Too short a cut will result in the whole body coming loose.
Step 11
Add some glue to the gap and thread wrappings that u used to secure the rubber.Also,now add some more lead wire to that gap till u reach the bead.Whip finish and tie of this thick thread.
Step 12
Add ur brown 14/0 thread and tie in the wingcase.
Bookmarks